Xiaomi M1803E6I Frp Reset by UMT QcFire Tool
Miracle Work Log’s :
Operation : Reset Mi Account
Checking for existing devices…Not Found
Turn Off phone, hold Vol UP + Vol DOWN and insert USB cable.
Some phones may need Special Boot Cable or TestPoint for EDL mode.
Found Port : Qualcomm HS-USB QDLoader 9008 (COM10)
Driver Info : Huawei Incorporated, qu_usb_serial.sys, 2.1.1.0
Connecting to phone…OK
Waiting for response…Ignored
Init Handshake Sequence…OK
Hardware ID : E1600400 [8953] 00000000
OPK_DATA : 079E496E26A477B120DFCD85DF7E4AD067164D8292DDD379930D5891E3D8240B
Initializing Protocol…OK
Using Auto Loader Selection [1]
Preparing Loader…Done
Sending Loader [8953]…Done
Executing Loader…OK
Detecting Chip Type…OK
Hardware : 8953, eMMC, 32 GB
LU Count : 1 [0x03A3E000]
WARNING! High Speed Driver is not installed.
Please install driver from QcFire\Drivers folder using Device Manager.
Payload Info : In: 65536 [4096], Out: 1048576, Sector Size: 512
Reading Partition Table…OK
Reading Device Information…OK
Device : Xiaomi Redmi S2 [ysl]
Software : PKQ1.181203.001, V10.3.5.0.PEFMIXM [Fri Sep 6 14:05:22 WIB 2019]
Android Ver. : 9
Patch Level : 2019-09-01
Resetting Mi Account Data…Done
Preparing Data…Done
Formatting Userdata…Done
When phone is completely ON, connect to Internet and add Mi Account.
————– INFORMATION ————–
New Firmware may cause hang on logo.
In such case, you need to flash phone to recover.
Or downgrade firmware and try Reset Mi Account again.
Operation Finished.
QcFire Ver. 5.0